1 | Wear indicator electrical connector |
2 | Locking pin |
3 | Cross spring |
4 | Brake lining |
G42.10-3249-12
| Remove/install | ||
Danger | Risk of death caused by vehicle slipping or toppling off during lifting | Only lift vehicle at the lift support points specified by the vehicle manufacturer. | |
1 | Raise front axle and lower onto jack stands | ||
2 | Remove front wheels | Spherical collar nut | |
Pressure plate nut | |||
3 | Detach cover panel above the brake wear indicator contact | Only on brake caliper with wear indicator. | |
4 | Disconnect wear indicator electrical connector (1) | Only on brake caliper with wear indicator. | |
5 | Remove securing pins (2) and take out cross spring (3) | ||
6 | Pull out brakepads (4) | Installation: Only replace brakepads (4) in sets per axle. | |
Paste, hot lubrication 1 kg, DBL 6879.20 | |||
Puller | |||
7 | Push back piston | Resetting device | |
| Check | ||
8 | Clean brake parts and check for wear and damage | Spirit | |
Brake caliper brush | |||
If wear or damage present | |||
| |||
Replace appropriate parts. | |||
9 | Check brakepads (4) and brake disks for wear | ||
| Model 437.4 | ||
If wear or damage present | |||
| |||
Replace appropriate parts. | |||
10 | Install in the reverse order | ||
| Check | ||
11 | Press brake pedal repeatedly and build up brake pressure | ||
12 | Check brake fluid level, correct if necessary | ||
| |||
13 | Check unobstructed movement of front wheels |
000 589 26 68 00
Brake caliper brush
001 589 43 33 00
Puller
000 589 52 43 00
Resetting device