Shown on model 910 with code MJ8 (ECO start/stop function) |
1 | Brake fluid reservoir |
2 | Feed hose |
3 | Screw |
4 | Electrical connector |
5 | Sealing rings |
D42.10-1207-05
Danger | Risk of accident when commissioning the vehicle due to a lack of braking effect when the service brake is operated for the first time after repair work. | Before starting the engine, actuate brake pedal several times until pressure is built up and maintained in the brake system. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Topical note | Notes on externally invisible brake fluid loss | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on working on clutch operating system | Model 907 with transmission 700.790 | |
Topical note | Brake fluid notes | ||
Topical note | Notes on repairs to brake system | ||
| Remove/install | ||
1 | Extract brake fluid from brake fluid reservoir (1). | To do so, open brake fluid reservoir (1). | |
Commercially available devices/tools | |||
2 | Remove feed hose (2) from clutch master cylinder. | Model 907 with transmission 700.790, 711.6 | |
Catch escaping brake fluid using a suitable rag and seal openings. | |||
Record plug | |||
3 | Disconnect electrical connector (4). | ||
| Clean | ||
4 | Clean area surrounding brake fluid reservoir (1) to master brake cylinder. | Assembly cleaner | |
5 | Remove bolt (3) . | Screw/bolt, brake fluid reservoir to master brake cylinder | |
6 | Remove brake fluid reservoir (1). | Catch escaping brake fluid using a suitable rag and seal openings. | |
Installation: Replace sealing rings (5). | |||
Record plug | |||
7 | Install in the reverse order. | ||
Bleeding | |||
8 | Bleed brake system. | ||
Model 907 with transmission 700.790, 711.6 |
129 589 00 91 00
Record plug