Remove/install propeller shaft intermediate bearing and replace grooved ball bearing

AR41.10-P-0100CW

15.04.2013

MODEL

204, 207, 212, 218, 231

P41.10-2002-11

	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
 	Remove/install
1	Remove propeller shaft	MODEL 204, 207	AR41.10-P-0050CW
		MODEL 212, 218	AR41.10-P-0050EW
		MODEL 231	AR41.10-P-0050RK
2	Separate front propeller shaft (1) and rear propeller shaft (2) at the slide connection		AR41.10-P-0050-05TX
		 Installation: When fitting the propeller shafts (1, 2) together, make sure that the marks line up with each other.
		Long-life grease	*BR00.45-Z-1001-06A
3	Pull boot (4) off front propeller shaft (1)	 Installation: Replace damaged rubber boot (4) and ensure that it is seated correctly.
4	Detach rubber mount (7b) together with grooved ball bearing (8) from rear propeller shaft (2)		AR41.10-P-0100-07TX
			AR41.10-P-0100-05TX
		 Puller, two-arm	*000589883300
		 Puller arms	*129589003400
5	Press grooved ball bearing (8) out of rubber mount (7b)		AR41.10-P-0100-02TX
		 Installation: Press rubber mount (7b) together with grooved ball bearing (8) onto joint fork of rear propeller shaft (2).
		 Drift	*126589031500
		 Removal and installation tool	*116589094300
6	Install in the reverse order

116 589 09 43 00

Removal and installation tool

129 589 00 34 00

Puller arms

126 589 03 15 00

Drift

000 589 88 33 00

Puller, two-arm

Repair materials

Number	Designation	Order number
BR00.45-Z-1001-06A	Long-life grease	A 000 989 63 51 11