000 588 04 19 00
Inclination meter
Measurement, absolute angle at flange of front axle differential (1) |
021 | Adapter for transmission |
021a | Spirit level |
086a | Measuring sensor |
086b | Measuring sensor connecting cable |
11 | Front axle gear flange |
P41.10-2341-11
1 | Clean contact surface of adapter for transmission (021) at flange of front axle differential (11). |
2 | Position (magnetically) adapter for transmission (021) at flange of front axle differential (11). |
3 | Align adapter for transmission (021) horizontally in transverse direction using spirit level (021a). |
4 | Place measuring sensor (086a) on support plate of adapter for transmission (021). |
During each measurement, the measuring sensor connecting cable (086b) must point in the direction of travel, else the measurement will be incorrect. Ensure that the measuring sensor (086a) sits correctly in the bores of the support plate, else the measurement will be incorrect. If the measuring sensor (086a) is not positioned horizontally, a fault message appears. The measured angle cannot be read out or stored. |
5.1 | If the electronic inclinometer is used or if measurement is performed using the electronic propeller shaft inclinometer in inclination measuring mode, only the absolute angle will be measured. |
The articulation angle must be calculated using a data sheet. The measured value must not be stored. |
5.2 | If the electronic propeller shaft inclinometer with memory extension is used or the electronic inclination-propeller shaft inclinometer with memory extension is used in articulation angle measuring mode. |
A confirmation message appears briefly. Indication of measurement readiness for the next angle then appears. |