Remove/install propeller shaft intermediate bearing

AR41.10-D-0101H

29.6.10

MODEL 906
Propeller shaft center support bearing (without protective caps) on sliding piece with 2- and 3-piece propeller shaft

D41.10-1122-06

1 Rear propeller shaft

2 Clamp

3 Rubber boot

4 Clamp

5 Propeller shaft center support bearing

6 Front propeller shaft

7 Shim (5 mm)

 	Remove/install
1	Remove propeller shaft		AR41.10-D-0050H
2	Remove rubber boot (3)	 Installation: Replace rubber boot (3). Ensure that rubber boot (3) is seated properly.	AR41.10-D-0101-01A
		MB multipurpose grease	*BR00.45-Z-1017-06A
3	Detach propeller shaft center support bearing (5)		AR41.10-D-0101-02A
			*000589453300
			*366589021500
		 Installation: Drive on propeller shaft center support bearing (5) as far as the end stop using drift. Do not drive on propeller shaft center support bearing (5) further than the drift permits as the installed dimension is determined by the drift. If a propeller shaft center support bearing (5) with shim (7) is removed, a propeller shaft center support bearing (5) with shim (7) must also be installed. If this is not observed humming, droning and starting noise may be heard.
			*906589001500
4	Check all parts for wear and damage	 Replace parts if necessary.
5	Install in the reverse order

366 589 02 15 00

000 589 45 33 00

Puller

Drift

906 589 00 15 00

Drift

Repair materials

Number	Designation	Order number
BR00.45-Z-1017-06A	MB multipurpose grease	A 001 989 34 51 11