Remove/install flexible coupling of drive shaft

AR41.10-D-0040WE

21.12.11

MODEL 906 with TRANSMISSION 722.9

D41.30-0001-09

Shown on model 906 with
2-piece propeller shaft

1 Bolts

2 Propeller shaft

5 Flex disk

6 Bolts

3 Securing clip

4 Bolts

 	Remove/install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Move selector lever to N position
2	Lift/jack up vehicle		AR00.60-D-1000H
3	Mark position of drive shaft (2) relative to output flange of transmission
4	Remove screws/bolts (4)	 Hold nuts
			*BA41.10-N-1011-01B
5	Remove bolts (1), detach drive shaft (2) from flexible coupling (5) and place onto retaining bracket (3)	 Installation: Note installation position of drive shaft (2).
			*BA41.40-N-1001-01A
6	Remove bolts (6) and flexible coupling (5)	 Installation: Replace bolts (6).
			*BA41.10-N-1012-01B
		Pin wrench	*901589000700
	Checking
7	Check flexible coupling (5) for wear, replace if necessary
8	Install in the reverse order

 Propeller shaft

Number	Designation				Model 906 without code ZG1/ZG2/ZG3/ ZG4


BA41.10-N-1011-01B	Bolt, flexible coupling to propeller shaft	M12x1.5		Nm	58
BA41.10-N-1012-01B	Bolt, flexible coupling to transmission	M121.5	Stage 1	Nm	60
			Stage 2	°	60

 Propeller shaft intermediate bearing

Number	Designation			Model 906


BA41.40-N-1001-01A	Bolt, propeller shaft intermediate bearing to frame floor	M10	Nm	-
		M121.5	Nm	135

Pin wrench

901 589 00 07 00