N40.20-2049-11
1 Cam bolt
Modification notes
| Checking | ||
Measure vehicle level at front and rear axles with electronic inclinometer | Use the measured vehicle level to look up the specified values for the toe-in on the table sheet and note down these values. | ||
Toe at vehicle level | |||
Toe at vehicle level | |||
3 | Perform wheel alignment check | During the chassis alignment, the actual chassis data should be measured (independently of the vehicle level). | |
This data is measured according to the specifications of the axle alignment device manufacturer. | |||
4 | Check the toe adjustment on the right and left side of the vehicle | Compare the toe-in values according to the vehicle level with the actual values measured during the chassis alignment. | |
Adjust | |||
5 | Adjust toe | Replace cam bolt (1) and nut if not yet replaced during previous work. Raise axle half to replace cam bolt (1). | |
Adjust toe-in to specified value using cam bolt (1) at bearing of left and right semi-trailing arm. | |||
Permitted difference between right and left side of vehicle for rear-axle toe | |||
|
Inspection values for toe-in at rear axle
Number | Designation | Model 636 | |
BE40.20-N-1001-10E | Toe at vehicle level | +5.80° | -0° 21' (10') |
+4.90° | -0° 19' (10') | ||
+4.20° | -0° 17' (10') | ||
+3.40° | -0° 14' (10') | ||
+2.70° | -0° 12' (10') | ||
+2.00° | -0° 10' (10') | ||
+1.30° | -0° 07' (10') | ||
+0.60° | -0° 05' (10') | ||
-0.00° | -0° 03' (10') | ||
BE40.20-N-1002-10E | Toe at vehicle level | -0.60° | -0° 01' (10') |
-1.20° | +0° 02' (10') | ||
-1.80° | +0° 04' (10') | ||
-2.30° | +0° 06' (10') | ||
-2.90° | +0° 08' (10') | ||
-3.40° | +0° 10' (10') | ||
-3.80° | +0° 12' (10') | ||
-4.30° | +0° 14' (10') | ||
-4.70° | +0° 16' (10') | ||
BE40.20-N-1003-10E | Permitted difference between right and left side of vehicle for rear-axle toe | ° | 10' |
Control arm