| Measuring, adjusting | ||
1 | Drive the vehicle onto the measuring station and secure using the parking brake | The measuring system must be approved by Mercedes-Benz. | |
2 | Carry out conditions and tests for chassis alignment | ||
3 | Switch off the easy entry/exit for the driver seat and steering wheel | Vehicles with code 275, Memory package (driver seat, steering column, mirrors) | |
Otherwise the driver seat and steering wheel move into a different position if the driver door is opened or closed for example. The driver seat may be damaged when the brake pedal jack is installed. | |||
The system is switched off via the COMAND system. | |||
4 | Open the driver door, disembark and raise and lower the vehicle level again from outside; to do this, press the vehicle level button on the cockpit switch group | Raising and lowering the vehicle reduces play in the suspension. Raise: The indicator lamp in the button lights up Lower: The indicator lamp in the button is Off. The vehicle must not be loaded again. | |
5 | Using the adapter, install the brake pedal retaining tool between the pedal and the driver seat | Protect the brake pedal and driver seat against damage otherwise the brake pedal or driver seat may be damaged. | |
| |||
| |||
6 | Shift the automatic transmission into position "P" using the selector lever | ||
7 | Open window on driver door and close driver door | Preparations for checking steering lock. The vehicle must not be loaded again. | |
8.1 | Switch off ignition | Model 216, model 221.1 without code Z07 Top protection | |
8.2 | Remove ignition key from ignition lock and store outside the vehicle | Model 221.1 with code Z07 Top protection | |
Under no circumstances store the ignition key in the vehicle, otherwise it is possible to be shut out of the passenger compartment during the tests | |||
9 | Attach Mercedes-Benz quick-clamping devices | ||
10 | Fit on measuring heads | ||
11 | Unlock turnplates and sliding platforms | ||
12 | Check vehicle level at front and rear axle using electronic inclinometer and adjust if necessary | Depending on the measurement result the vehicle level must be adjusted at the front and rear axle. | |
13 | Perform initial measurement | ||
14 | Checking rear axle camber | According to results of initial measurement. | |
The camber at the rear axle is not adjustable. | |||
15 | Adjust rear-axle toe | According to results of initial measurement. | |
16 | Adjust camber and caster at the front axle | According to results of initial measurement. | |
17 | Adjust front axle toe | According to results of initial measurement. | |
18 | Check toe-out on turns | According to results of initial measurement. | |
19 | Perform final measurement | ||
20 | Detach sensors | ||
21 | Detach Mercedes-Benz quick-clamping devices | ||
22 | Remove brake pedal jack tool with its adapter | | |
| |||
23 | Drive vehicle off measuring system | ||
24 | Lock turntables and sliding platforms |
211 589 00 31 00
Adapter for brake pedal winch
Brake pedal winch
000 589 18 31 00