1 | Pressure gage |
2 | Hose |
W35.50-1130-03
2 | Hose |
3 | Hydraulic unit |
4 | Test connection |
W35.50-1131-06
Warning | Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure.Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
| Check | ||
1 | Secure vehicle on rear axle using two chocks to prevent it from rolling away. | ||
2 | Remove cap from hydraulic unit (3). | ||
3 | Connect hose (2) to manometer (1). | Hose | |
Pressure gage | |||
4 | Connect hose (2) to test connection (4) of hydraulic unit (3). | Hose | |
5 | Start engine and raise leading axle. | Keep engine running as the leading axle is lowered when the engine is stopped and the ignition switched off, so the system is no longer pressurized. | |
6 | Read off pressure on manometer (1). | System pressure | |
If the read-off pressure does not correspond to the specified system pressure, | |||
| |||
determine cause and correct. | |||
7 | Stop the engine and switch off the ignition. | The leading axle is lowered when the engine is stopped and the ignition switched off. | |
8 | Disconnect hose (2) and the manometer (1). | ||
9 | Mount cap onto hydraulic unit (3). | ||
10 | Remove wheel chocks from rear axle. |
400 589 01 91 00
Hose
000 589 06 21 00
Pressure gage