Rear axle | 741.412 in model 900.63 |
Rear axle | 741.412/415 in model 906.11/13/21/23/61/63/71/73 |
Rear axle | 741.413/414/416/420 in model 906.15/25/65 |
Rear axle | 741.413/414/420 in model 900.65 |
Rear axle | 741.421/422/423/453/454/455 in model 906 |
Rear axle | 741.421/455 in model 900 |
Rear axle | 741.428 in model 8AC906.133/631/633/635 |
with code ZL3 (National version for Latin America) | |
Rear axle | 741.429 in model 8AC906.153/155/655/657 |
with code ZL3 (National version for Latin America) |
Shown on model 906.633 with rear axle 741.412 |
1 | Screws/bolts |
2 | End cover |
3 | Rear axle |
D35.31-0001-11
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Remove | ||
1 | Raise vehicle | ||
2 | Drain oil from rear axle (3) | ||
| Rear axle 741.428 in model 8AC906.133/631/633/635 | ||
| Rear axle 741.412 in model 900.63 | ||
Collect oil in suitable container. | |||
3 | Remove screws/bolts (1) | ||
4 | Remove end cover (2) | Release end cover (2) from the rear axle (3) using suitable tool. | |
Observe installation position of end cover (2). | |||
| Install | ||
5 | Clean sealing surfaces on the end cover (2) and on the rear axle (3) | Replace seal. | |
6 | Fit on end cover (2) | ||
7 | Screw in screws/bolts (1) | Replace screws/bolts (1) with locking splines. | |
Bolt, cover to rear axle housing | |||
8 | Pour oil into rear axle (3) | ||
| Rear axle 741.428 in model 8AC906.133/631/633/635 | ||
| Rear axle 741.412 in model 900.63 | ||
| Check | ||
9 | Check rear axle (3) for leaks | ||
10 | Lower vehicle |
Axle housing |
Number | Designation | Rear axle 741.412 in model 900.63 | Rear axle 741.413/414/416/420/429 in model 906 | |||
BA35.25-N-1001-01A | Bolt, cover to rear axle housing | M8 | Stage 1 | Nm | 25 | - |
Stage 2 | ° | 60 | - | |||
M10 | Stage 1 | Nm | - | 35 | ||
Stage 2 | ° | - | 45 |