AR35.30-D-4815-06H | Measure difference dimension of drive pinion | ||
| Drive pinion end face machining changed | 741.412/413/414/415/416/420 |
001 589 53 21 00
363 589 02 21 00
140 589 16 23 00
906 589 01 21 00
Dial indicator
Adjustment device
Measuring plate
Dial indicator holder
D35.30-0062-01
1 Set dial indicator (3) on measuring piece (2) to zero with 8 mm preload.
With ring gear dia. 215 mm use lower side, with ring gear dia. 245 mm use higher side.
Measurement setup
A Length dimension of measuring piece
D35.30-0063-01
2 Remove measuring piece (2) and insert drive pinion with bearing and magnetic disk (5).
3 Determine and note difference dimension of drive pinion between length dimension of measuring piece (A) and actuaI dimension of drive pinion (B).
Add read-off value 0.03 mm as, when installing, the drive pinion is drawn deeper into the axle housing by this dimension.
During the measuring process pull the drive pinion downwards and rotate simultaneously.