Detach tapered roller bearing from ring gear

ประเภท ar · หัวข้อ 35.30 · เวอร์ชัน 0104 · 2019-04-20

ใช้กับ: Rear axle 741.710 in model 958 Rear axle 746.209/231/233/305 in model 934.2, 938.1, 958 Rear axle 746.213/230 in model 934.2 Rear axle 746.213/230 in model 958.2/4 except code ZC8 (New Final Drive-Top Performance Light) Rear axle 746.218/225 in model 382.1, 634.0 Rear axle 748.590/594 in model 934.2, 958.4

ไม่มีใน “th” แสดงเป็น อังกฤษ

AR35.30-B-4301-02GA	Detach tapered roller bearing from ring gear
 Caution	Risk of injury caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A

Rear axle	741.710 in model 958
Rear axle	746.209/231/233/305 in model 934.2, 938.1, 958
Rear axle	746.213/230 in model 934.2
Rear axle	746.213/230 in model 958.2/4
	except code ZC8 (New Final Drive-Top Performance Light)
Rear axle	746.218/225 in model 382.1, 634.0
Rear axle	748.590/594 in model 934.2, 958.4

Detach tapered roller bearing from ring gear

741 589 05 63 00

Thrust piece

000 589 89 33 00

Puller

 The differential tapered roller bearings must be replaced as a set.
Remove

1	Use the  pressure part as a support on the crown gear (1).

 Ensure the correct pressure part position when fitting it on the differential.

2	Install the puller claws on the  underside of the taper roller bearing cage (2) .

3	Support the puller over the pressure part and pull the taper roller bearing (2) out of the differential case (1).

B35.31-0025-02

เอกสารที่อ้างถึง

as0000z001701a