P35.20-2219-09
1 Rear axle carrier
4 Tie rod
7 Wheel carrier
4a Eccentric disk
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | |
| Notes on self-locking nuts and bolts | ||
While working on the rear axle care must be taken to ensure that the surface of aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced. | |||
Installation: Only tighten bolts and nuts of the chassis components in the curb condition. | |||
1 | Lower front rear axle carrier (1) | ||
2 | Mark installation position of eccentric disk (4a) | The toe-in is set ex-factory with the eccentric disk (4a). | |
3 | Remove tie rod (4) from wheel carrier (7) and rear axle carrier (1) | | |
| |||
4 | Install in the reverse order | ||
5 | Perform a wheel alignment check | Model 204 | |
Model 207 |
Tie rod