Remove/install center drive shaft with bearing

AR33.30-S-7706C

20.10.98

ENGINE 611.980 in MODEL 638

S33.30-4002-08

1 Center driveshaft

2 Bearing cap

3 Bracket

7 Retaining clip

9 Drive shaft

4 Screw

5 Plastic protective ring

6 Bearing

 	Remove/Install
1	Disconnect drive shaft (9)	 Tie back drive shaft (9).	AR33.30-S-6500M
2	Unscrew nuts on left and right struts of anti-roll bar	 Installation: Replace self-locking nut.
		 Turn up anti-roll bar.
			*BA32.35-N-1001-02B
3	Unscrew bolt (4) for bearing cover (2) on bracket (3)		*BA33.30-N-1005-01A
4	Remove brake caliper	 Do not disconnect the brake hose, but push it to one side so that it does not interfere with work.	AR42.10-S-0070A
5	Remove center drive shaft (1)	 Installation: Observe installation position of plastic protective ring (5).
		 Check condition of radial shaft seal and replace if necessary.
		 Puller	*638589013301
6	Remove bearing (6)	 Only when replacing the center drive shaft or bearing.
		 Puller	*638589023301
		 Drift	*638589031500
7	Install in the reverse order
	Check
8	Check for leaks

 Front axle anti-roll bar

Number	Designation		Model 638


BA32.35-N-1001-02B	Mounting of anti-roll bar to strut of shock absorber	Nm	62

 Front axle drive

Number	Designation		Model 638 with Series 611.980 engine


BA33.30-N-1005-01A	Bolt, cover of center drive shaft to generator support	Nm	12

638 589 02 33 01

Drift

Puller

638 589 01 33 01

638 589 03 15 00