230 589 00 34 00
Extraction and insertion tool
Assembly and removal tool supplementary kit
Extraction tool
Press out/in tool
202 589 04 43 00
124 589 05 43 00
220 589 06 43 00
P33.20-2242-11
Shown on model 169 steering knuckle with mounted suspension strut
Press out
1 Remove retaining ring of angular contact ball bearing (9n).
2 Place steering knuckle (5) onto workshop press with plate (09a).
Use part 07 from the 202 589 04 43 00 press-out tool.
3 Press angular contact ball bearing (9n) using thrust piece (09b) out of steering knuckle (5).
Use part 02 from 230 589 00 34 00 supplement set for extractor, insertion tool.
P33.20-2243-11
Pressing in
Installation: The pulse ring (encoder) for the rpm sensor is integrated into the angular contact ball bearing (9n). For this reason, it is important to make sure that the installation position of the angular contact ball bearing (9n) is correct. The points, the "Inside" inscription, or the black inner ring on the angular contact ball bearing (9n) must point towards the inside of the steering knuckle (5).
The marking is manufacturer specific. The magnetic side of the angular contact ball bearing (9n) must point towards the inside of the steering knuckle (5).
If incorrectly fitted, the rpm sensor will not detect any pulse signals.
4 Position angular contact ball bearing (9n), steering knuckle (5) and press-in tool (05b) onto workshop press.
Use part 01 from 230 589 00 34 00 supplement set for extractor, insertion tool.
5 Press angular contact ball bearing (9n) all the way in.
Make sure that the press-in tool (05b) is positioned on the center of the steering knuckle (5) when pressing in.
P33.20-2244-12
6 Turn steering knuckle (5).
7 Position steering knuckle (5) and press-in tool (05b and 05d) onto workshop press.
Use part 01 (05b) from 230 589 00 34 00 supplement set for extractor, insertion tool.
Use part 01 (05d) from 124 589 05 43 00 supplement set for extractor, insertion tool. Alternatively, the old angular contact ball bearing can also be used.
If necessary also shim part 07 (05c) from 220 589 06 43 00 the press out/in tool.
8 Press angular contact ball bearing (09n) all the way in.
Make sure that the press-in tool (05b and 05d) is positioned in the center of the steering knuckle (5) and angular contact ball bearing (9n) when being pressed in.
9 Mount retaining ring.
Check retaining ring is correctly seated in groove.