1 | Stabilizer link |
2 | Screw |
3 | Bearing cap |
4 | Screw |
5 | Bearing bracket |
6 | Front axle |
7 | Nut |
8 | Elastomer bearing (with bolt) |
9 | Bearing |
W33.10-1031-06
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
Notes on safety-relevant components | |||
| Remove | ||
1 | Move vehicle air suspension to driving level and park vehicle. | ||
2 | Mark installation position of elastomer bearings (8) relative to stabilizer link. | ||
3 | Remove nuts (7) and remove bolts (4). | ||
4 | Loosen screws (2) on left and right bearing cap (3). | ||
5 | Pull stabilizer link (1) downward and remove bearing brackets (5) from front axle (6). | ||
6 | Support stabilizer link (1) between bearing caps (3). | ||
7 | Detach screws (2) from bearing caps (3) and remove bearing caps (3). | ||
8 | Remove stabilizer link (1). | ||
| Check | ||
9 | Check right and left bearing (9) for damage and wear. | If damage or wear is present: | |
| |||
Replace bearings (9). | |||
10 | Check elastomer bearings (8) in stabilizer link (1) for damage and wear. | If damage or wear is present: | |
| |||
replace elastomer bearings (8) in stabilizer link (1). | |||
Hand pump | |||
Hydraulic hose (complete) | |||
Pulling device | |||
Supplementary set | |||
| Install | ||
11 | Mount stabilizer link (1) with bearing brackets (5) onto front axle (6). | Stabilizer link and bearing bracket to front axle | |
12 | Push stabilizer link (1) into bearings on vehicle frame bearing bracket and support stabilizer link (1). | ||
13 | Mount stabilizer link (1) with bearing cap (3) onto vehicle frame bearing bracket. | Bearing cap of stabilizer link to vehicle frame bearing bracket |
652 589 00 33 21
Hand pump
950 589 03 33 00
Pulling device
950 589 00 34 00
Supplementary set
652 589 00 33 23
Hydraulic hose (complete)