1 | Electrical connector |
2 | Actuating lever |
B120 | Travel sensor (automatically liftable trailing axle) |
W32.33-2127-06
| Remove | ||
1 | Switch off ignition | ||
2 | Detach electrical connector (1) from travel sensor (B120) | ||
3 | Remove operating lever (2) from travel sensor (B120) | ||
4 | Remove travel sensor (B120) from holder | ||
| Install | ||
5 | Mount travel sensor (B120) onto holder | Travel sensor to bracket | |
6 | Mount operating lever (2) onto travel sensor (B120) | Operating lever to travel sensor | |
7 | Connect electrical connector (1) to travel sensor (B120) | ||
8 | Connect diagnostic system, start XENTRY and perform quick test | Only if travel sensor (B120) was replaced. | |
The quick test is stored at the end of the diagnosis session as the initial quick test and can be printed out. | |||
9 | Calibrate travel sensor (B120) | Only if travel sensor (B120) was replaced. | |
The calibration process for the travel sensor (B120) is completely menu-assisted at: | |||
10 | Run final quick test, initial quick test and print out final quick test and file in a tamperproof manner | There must be no fault codes in the control units being updated. If necessary, process any fault codes in other control units, subject to a separate repair order. | |
11 | End Xentry and disconnect diagnostic system |