Shown on vehicle with code (ZG2) Permanent all-wheel drive |
1 | Tensioning device |
2 | Spring |
3 | Rubber stopper |
S32.20-4502-11
| Remove/install | ||
Warning | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
1 | Raise vehicle with vehicle lift | ||
2 | Install tensioning device (1) | Tensioning device | |
Clamping plates | |||
3 | Remove spring (2) | Installation: Ensure correct position of the spring (2). | |
4 | Detach rubber stops (3) from spring (2) | Installation: Check rubber stops (3) for wear and damage, replace if necessary. | |
5 | Install in the reverse order |
639 589 00 63 00
Clamping plates
203 589 01 31 00
Tensioning device