Shown on model 437.437 |
1 | Spring |
2 | Bracket |
3 | Shock absorber |
4 | Nut |
Pfeil | End stop |
G32.20-0005-12
Danger | Risk of death caused by vehicle slipping or toppling off during lifting | Only lift vehicle at the lift support points specified by the vehicle manufacturer. | |
Warning | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
| Remove | ||
1 | Tilt cab into repair position | Model 437.42/43 | |
2 | Disconnect shock absorber (3) from front axle | ||
3 | Lift up frame until the spring (1) is relieved and no longer makes contact with the front axle | ||
4 | Unscrew nut (4) and remove spring (1) with bracket (2) | Counterhold bolt. | |
If the complete wheel prevents the spring (1) cannot be removed. | |||
| |||
Lift front axle and remove complete wheel. | |||
| Install | ||
5 | Mount spring (1) as well as bracket (2) at top on spring bracket and screw on nut (4) approx. 4 to 5 turns of the thread | The end of the spring (1) must make contact with the end stop (arrow) of the bracket (2). | |
6 | Lower frame far enough to enable the bolt for the damper (3) to be positioned | Align the spring (1) for the centering ring on the front axle. | |
7 | Position bolt of damper (3) | ||
8 | Tighten nut (4) | Counterhold bolt. | |
Model 437.465Bolt, coil spring and suspension travel limiter to spring bracket | |||
Model 437.42/43Bolt/nut, bracket for coil spring to spring bracket | |||
9 | Lower frame completely | ||
10 | Tighten bolt on shock absorber (3) | Nut/bolt, shock absorber to front axle | |
11 | Lower cab | Model 437.42/43 | |
12 | Mount complete wheel and lower front axle | If the complete wheel was removed. | |
Model 437.420/421/425/426Spherical collar nut | |||
Pressure plate nut |