Shown with code 430 (Off-road package) |
1 | Transfer case |
2 | Electrical connector |
3 | Screw |
N15/7 | Transfer case control unit |
P28.19-A003-06
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Put transmission into neutral position. | | |
2 | Disconnect ground line from battery. | ||
3 | Lift vehicle with vehicle lift. | ||
4 | Remove cover under transfer case (1). | Transmission 725.0 in model 167 with engine 656 | |
Installation: Install cover under transfer case (1) only after leak test. | |||
5 | Remove shield plate from transfer case (1). | Transmission 725.0 in model 167 with engine 654.9 | |
Screw, shield to off-road bracket | |||
6 | Release and disconnect electrical connector (2). | ||
7 | Remove bracket of shield plate. | M61 | |
8 | Remove bolts (3). | Bolt, transfer case control unit to transfer case | |
9 | Remove transfer case control unit (N15/7). | Installation: | |
Installation: Replace seals. | |||
10 | Install in the reverse order. | ||
11 | Perform commissioning of transfer case control unit (N15/7). | When replacing the transfer case control unit (N15/7). | |
| |||
12 | Read out and delete fault memory. | ||
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
13 | Perform engine test run; while doing so, check transfer case (1) for proper operation and leak tightness. | ||
14 | Install cover under transfer case(1). | Transmission 725.0 in model 167 with engine 656 | |