Flushing out oil cooler with oil cooler pipe and torque converter

116 589 00 15 00

Hand pump

Drive shaft

210 589 00 71 00

P27.10-0005-01

A Flushing out torque converter

1 Fill torque converter half-full with automatic transmission fluid.

2 Insert flushing mandrel (063) in the torque converter and drive with a hand drill at low speed for approx. 2 minutes.

3 Drain ATF oil through a clean cloth via the drain plug (2) and allow the oil to drip out.



Repeat flushing process 2-4 times until the automatic transmission fluid runs out clean.
If there are metal chips in the cloth after flushing out, replace the torque converter.

P27.20-0217-01

B Flushing out oil cooler with oil cooler pipes

4 Screw oil cooler pipe (49) onto the hand pump (064) and flush out the oil cooler pipe as well as the oil cooler with automatic transmission fluid.



Ensure that the transmission fluid flows freely.

5 Then blow out the oil cooler and oil cooler pipes thoroughly with compressed-air.