AR26.60-W-7000C | Removing and installing hydraulic gear shift cylinder | 4.12.03 |
TRANSMISSION 715.570 in MODELS 950.5 /6, 952.5 /6, 953.6, 954.5 with CODE (GS3) "Hydraulic" transmission shift
TRANSMISSION 715.570 in MODEL 970, 972, 974, 976 with CODE (GS3) Hydraulic gearshift
W26.60-1143-12
1 Gear shift cylinder
2 Piston rod
3 Sealing ring
4 Hydraulic line
5 Hydraulic line
6 Driver for shift force assist
| Remove/install | ||
Danger! | Risk of injury caused by being caught or pinched as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
2 | Detach hydraulic lines (4 and 5) from shift cylinder for gear (1) | Identify installation position of hydraulic lines (4 and 5). Collect fluid which runs out. | |
| |||
| Notes on hydraulic fluid as per specification sheet 345.0 | ||
3 | Detach gear shift cylinder (1) | Press air line back slightly and hold. Pull out shift cylinder for gear (1) up to the stop, pull vertically upwards and remove. | |
Installation: Before inserting the piston rod (2) in the driver for shift force assist (6) pull out the piston rod (2) of the shift cylinder for gear (1) completely. Replace seal (3). | |||
| |||
4 | Install in the reverse order | ||
5 | Bleeding air from hydraulic-pneumatic shift-control mechanism (HPS) | Model 950, 952, 953, 954 | |
Models 970, 972. 974. 976 | |||
6 | Check leaktightness of shift cylinder |
Gearshift system