G26.60-A000-08
1 | Screw | 5 | Sleeve | |
2 | Shift | 6 | Guide pin | |
3 | Seal | 7 | Shift rods | |
4 | Splitter box actuating pin | A | Bearing point in transmission housing front section |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on self-locking nuts and bolts | ||
| Remove | ||
1 | Remove transmission positioner. | ||
2 | Remove splitter box actuating pin (4). | ||
3 | Remove screw/bolt (1). | ||
4 | Remove gearshift system (2). | ||
5 | Remove seal (3). | ||
6 | Remove sleeve (5). | ||
7 | Remove grease from bearing point in transmission housing front section (A). | ||
| Check | ||
8 | Check gearshift system (2), splitter box actuating pin (4) and sleeve (5) for damage and wear. | If wear or damage is detected: | |
| |||
Replace corresponding component. | |||
9 | Check guide pin (6) for damage and wear. | If wear or damage is detected: | |
| |||
Replace guide pin (6). | |||
Guide pin, gearshift system to front section of transmission housing | |||
| Install | ||
10 | Install sleeve (5). | ||
11 | Fit new seal (3). | ||
12 | Coat bearing point in transmission housing front section (A) with grease. | Synthetic grease 50 g | |
13 | Install gearshift system (2). | Insert gearshift system (2) into guide pin (6), shift rods (7) and bearing point in transmission housing front section (A). | |
14 | Screw in screw (1). | Screw, gearshift system to front section of transmission housing | |
15 | Install actuating pin of splitter box (4). | ||
16 | Install transmission positioner. |