Gear set, shafts
Number | Designation | Trans-mission | Trans-mission | Trans-mission | |||
BA26.50-N-1002-01D | Mounting bolt, reverse idler shaft to transmission housing | M8 | Nm | 20 | 20 | 20 | |
D26.50-1209-11
1 Screw
2 Cylindrical roller bearing
3 Reverse idler gear
4 Thrust plate
5 Reverse idler shaft
6 Bearing shell
7 Rear section of transmission housing
Removing
1 Unscrew bolt (1).
2 Remove bearing shell (6).
3 Remove thrust plate (4), reverse idler gear (3) and cylindrical roller bearing (2).
4 Pull out reverse idler shaft (5).
5 Check all components for damage and wear and replace defective components.
Install
6 Insert reverse idler shaft (5)
7 Insert bolt (1) and align threaded hole of reverse idler shaft (5) with bolt (1).
8 Pull out bolt (1) again.
9 Oil reverse idler shaft (5), cylindrical roller bearing (2) and thrust plate (4) lightly with automatic transmission fluid.
10 Slide cylindrical roller bearing (2), reverse idler gear (3) and thrust plate (4) onto reverse idler shaft (5).
Transmission 711.68: The groove on the reverse idler gear (3) must point toward the drive side.
11 Install bearing shell (6) and tighten down with bolt (1), .
Replace self-locking bolt (1).
The inscription on the bearing shell (6) must point toward the drive side.