Remove/install pressure control valve

AR26.45-W-0054A

30.11.11

TRANSMISSION 715.500 /507 /510 /513 /517 /520 /527 /540 with CODE (N56) Transmission independent power take-off (live power take-off) i = 1.48

TRANSMISSION 715.500 /507 /510 /513 /517 /520 /527 /540 with CODE (N57) Transmission independent power take-off (live power take-off) i = 1.09

W26.45-1044-11

1 Banjo bolt

2 Hydraulic line

3 Pressure control valve

4 Compressed-air line banjo bolt

5 O-ring

6 Screw

7 O-ring

 	Remove/install
1	Clean transmission housing in the area of the pressure regulator valve (3)
2	Detach compressed-air line		*BA26.45-N-1003-01D
3	Detach hydraulic line (2)	 Installation: If a new or repaired pressure regulator valve (3) is installed, a new banjo bolt (1) must be installed.
			*BA26.45-N-1004-01D
4	Detach pressure regulator valve (3)	 Installation: Use new O-rings (5 and 7).
			*BA26.45-N-1002-01D
5	Install in the reverse order
 Danger!	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
6	Allow the engine to idle and switch the power take-off on and off several times
7	Check transmission oil level and refill with transmission oil if necessary	 The transmission oil must reach the bottom edge of the oil filler opening.
	Manual transmission - oil change	Transmission 715.500/507/510/513/520/540	AP26.00-W-2601A
		Transmissions 715.517/527	AP26.00-W-2601G

 PTO

Number	Designation		Transmission 715.500/507/510/513/ 517/520/527/540 with code N56 (NMV 200), code N57 (NMV 150)


BA26.45-N-1002-01D	Pressure regulator valve to PTO	Nm	21
BA26.45-N-1003-01D	Bolt of compressed air line to pressure regulator valve	Nm	18
BA26.45-N-1004-01D	Bolt of hydraulic line to pressure regulator valve	Nm	40