1 | Sliding sleeve |
2 | Screw plug |
3 | Spring |
4 | Shift fork |
5 | Sealing ring |
6 | Retaining ring |
7 | Thrust piece |
8 | Jack |
9 | Sealing ring |
10 | Shift rod |
11 | Support ring |
12 | Seal |
13 | Shift cylinder with solenoid valve |
14 | Screw |
15 | Washer |
S23 | Power take-off 1 indicator switch |
W26.45-0067-06
| Remove | ||
1 | Unscrew power take-off 1 indicator switch (S23) and remove sealing ring (5) | ||
2 | Remove thrust piece (7) from housing and remove retaining ring (6) | ||
3 | Remove shift cylinder with solenoid valve (13) | ||
4 | Unscrew screw plug (2) and remove spring (3) | ||
5 | Take out sliding sleeve (1) and shift fork (4) | Push back the shift fork (4) until the sliding sleeve (1) is free. | |
6 | Remove bush (8) | Only if damaged or worn. | |
| Install | ||
7 | Install bush (8) using suitable drift | Install the bush (8) such that the butt joint on the right is in the middle. | |
8 | Insert shift fork (4) in the housing | Push back the shift fork (4) until the sliding sleeve (1) can be installed. | |
9 | Push on sliding sleeve (1) and insert shift fork (4) into radial groove of sliding sleeve (1) | The shift teeth of the sliding sleeve (1) must point toward the drive side. | |
10 | Install shift cylinder with solenoid valve (13) together with shift rod (10) | ||
Coat slide surfaces of shift rod (10) with lubricant. | |||
Long-life grease | |||
11 | Insert spring (3) and screw in screw plug (2) | Screw in the screw plug (2) so that it is flush with the housing. Then continue turning until the plug is recessed by 0.3 to 1.0 mm. | |
12 | Push retaining ring (6) onto thrust piece (7) and insert thrust piece (7) into housing | Coat thrust piece (7) with lubricant. | |
Long-life grease | |||
13 | Remove power take-off 1 indicator switch (S23) and tighten sealing ring (5) | Replace sealing ring (5). | |
Indicator switch to shift housing |