1 | Screw plug |
2 | Spring |
3 | Shift housing of second output |
4 | Thrust piece |
5 | Retaining ring |
6 | Sealing ring |
7 | Jack |
8 | Shift fork |
9 | Sealing ring |
10 | Shift rod with piston |
11 | Support ring |
12 | Seal |
13 | Shift cylinder with solenoid valve |
14 | Bearing housing (with dual drive with flange) |
15 | Hydraulic pump (with dual drive with flange and Meiller pump) |
16 | Seal |
17 | Sliding sleeve |
18 | Shim |
19 | Centering ring |
S79 | Power take-off 2 indicator switch |
W26.45-1211-06
| Notes on self-locking nuts and bolts | ||
| Remove | ||
1.1 | Remove bearing housing (14) | Power takeoff without hydraulic pump | |
1.2 | Remove hydraulic pump (15) | Power takeoff with hydraulic pump | |
2 | Remove shift housing of second output (3) | ||
| Disassemble | ||
3 | Unscrew power take-off 2 indicator switch (S79) and remove sealing ring (6) | ||
4 | Remove thrust piece (4) from shift housing of second output (3) | ||
5 | Remove shift cylinder with solenoid valve (13) and shift rod with piston (10) | ||
6 | Unscrew screw plug (1) and remove spring (2) | ||
7 | Take shift fork (8) and sliding sleeve (17) out of the shift housing of the second output (3) | ||
8 | Remove socket (7) | Internal extractor | |
Counter stay | |||
| Assemble | ||
9 | Install bush (7) | Use a suitable drift. | |
10 | Slide shift fork (8) into radial groove of sliding sleeve (17) and insert sliding sleeve (17) into shift housing of second output (3) | The collar of the sliding sleeve (17) must point toward the drive side. | |
11 | Install shift cylinder with solenoid valve (13) and shift rod with piston (10) | ||
Install a new seal (12). | |||
12 | Insert spring (2) and screw in screw plug (1) | Coat the screw plug (1) with thread locking compound and screw in flush with the sealing surface, then turn further by approx. 90° until the plug is recessed by approx. 0.3_mm. | |
Quick-acting adhesive, Loctite 270 | |||
13 | Insert thrust piece (4) into shift housing of second output (3) | Coat thrust piece (4) with lubricant. | |
Long-life grease | |||
14 | Install power take-off 2 indicator switch (S79) | Replace sealing ring (6). | |
Indicator switch to shift housing | |||
| Install | ||
15 | Mount shift housing of second output (3) | ||
16.1 | Install hydraulic pump (15) | Power takeoff with hydraulic pump | |
16.2 | Install bearing housing (14) | Power takeoff without hydraulic pump | |
Nut, second power take-off to power take-off |
000 589 33 33 00
Counter stay
000 589 25 33 00
Internal extractor