Remove/install second output

AR26.45-W-0025A

17.08.2015

1	Seal
1.1	Seal (separated)
2	Shim
3	Compressed-air line
4	Shift housing
5	Seal
6	Threaded pins
7	Bearing housing (with output flange)
8	Nut
9	Hydraulic pump
10	Electrical connector
S79	Power take-off 2 indicator switch
Pfeile	Separation point

W26.45-0048-06

	Notes on compressed air connection systems		AH00.18-N-0001-01A
 	Remove/install
1	Detach drive shaft from bearing housing (7)	Only on power take-off without hydraulic pump.
		 Propeller shaft to power take-off	*BA26.45-N-1011-04B
2	Disconnect electrical connector (10)
3	Detach compressed-air line (3)
4.1	Remove bearing housing (7)	Power takeoff without hydraulic pump
		 Collect oil which runs out in a suitable container.
		 Installation: Clean sealing surfaces and replace seal (5).
		 Nut, second power take-off to power take-off	*BA26.45-N-1016-04B
4.2	Detach hydraulic pump (9)	Power takeoff with hydraulic pump
			AR26.45-W-0002A
		 Do not separate hydraulic lines. Collect oil which runs out in a suitable container.
		 Installation: Clean sealing surfaces and replace seal (5).
5	Remove shift housing (4) and shim (2)	 Installation: Clean sealing surfaces and replace seal (1). Separate the seal (1) at the separating point (arrows) and put on the seal (1.1).
6	Install in the reverse order
7	Check transmission oil level, adjust to correct level if necessary
		Transmission 715.320/350/370/380/500/507/510/513/515/525/540/561 Transmission 715.520 without code G02 (Torque converter clutch (WSK)) Transmission 715.570 except in model 949	AP26.00-W-2601A
		Transmission 715.520 with code G02 (Torque converter clutch (WSK))	AP26.00-W-2601B
		Transmission 715.570 in model 949	AP26.00-W-2601R

 Power take-off

Number	Designation			Transmission 715 with PTO 123, 124
BA26.45-N-1011-04B	Propeller shaft to power take-off	M8	Nm	25
		M10	Nm	60
		M12	Nm	100

 Power take-off

Number	Designation		Transmission 715 with PTO 123, 124
BA26.45-N-1016-04B	Nut, second power take-off to power take-off	Nm	70