Disassemble/assemble power take-off 2 output shaft

AR26.45-W-0013-01E

Disassemble/assemble power take-off 2 output shaft

 Warning

Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.

Wear protective gloves, protective clothing and safety glasses, if necessary.

AS00.00-Z-0002-01A

Transmission

715.316/352/356/360/366/371/376/381/386/508/518/523/528/536/537/538/539/571

with power take-off 135

Check values for power take-off

Number

Designation

Transmission 715 with PTO 135

BE26.45-N-1003-03E

Axial play of output shaft bearing in housing

Power take-off 1

mm

0...0,06

Power take-off 2

mm

0,02...0,08

Disassemble

1

Remove output shaft for power take-off 2 (15) and the tapered roller bearing (14) using the  puller Ø 28-37 mm and the  counter stay.

2

Detach tapered roller bearing (14) from output shaft of power take-off 2 (15).

 To do so, the following special tools are required:
 Hand pump,  hydraulic hose (complete), the  hydraulic cylinder, the  adapter, the  adapter and  gripper.

3

Detach tapered roller bearing (16) with the  puller from the output shaft of power take-off 2 (15).

4

Using the internal extractor  and countering support  , pull the tapered roller bearing outer race (16.1) out of the housing (1).

5

Remove the shim (17) from the housing (1).

Assembly

6

Heat both tapered roller bearings (14, 16) to approx. 80 °C, mount onto output shaft of power take-off 2 (15) and readjust using suitable drift.

7

Insert shim (17) in the housing (1).

8

Measure from housing sealing surface on shim (17) using depth gauge, dimension (A).

9

Remove shim (17) from housing (1).

10

Measure thickness of retaining ring (13) using vernier caliper, dimension B.

11

Install circlip (13) in the housing (1).

12

Measure from housing sealing surface on retaining ring (13) using depth gauge, dimension (C).

 Pull retaining ring (13) upwards here.
Otherwise, the play in the groove can lead to measuring errors.

13

Remove circlip (13) from the housing (1).

14

Place tapered roller bearing outer races (14.1, 16.1) on the tapered roller bearings.

15

Measure height of power take-off 2 output shaft (15) using vernier caliper, dimension (D).

16

Calculate dimension (E):
Dimension (E) = dimension (A) – dimension B – dimension (C).

 Dimension (E) must be greater than dimension (D) by the amount of end play specified in the table.
An end play of 0.05 mm should be aimed for.
Compensate for any deviations by installing an appropriate shim (17.
The actual axial play can be determined as follows:
Dimension (E) – dimension (D) = Actual end play.

17

Insert determined shim (17) into housing (1).

18

Install tapered roller bearing outer race (16.1) in the housing (1) using a suitable drift.

19

Insert power take-off 2 output shaft (15) into housing (1).

20

Install tapered roller bearing outer race (14.1) using a suitable drift.