1 | Seal |
2 | Cover |
3 | Radial shaft sealing ring |
4 | Nut |
5 | Output flange |
6 | Pressure plate |
7 | Screw |
8 | Retainer wrench |
9 | Drift |
W26.45-0066-06
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
Notes on safety-relevant components | |||
| Remove | ||
1 | Remove propeller shaft from power take-off. | ||
2 | Remove power output flange (5). | Counterhold output flange (5) with retainer wrench (8). Use puller in the event of sluggishness. | |
Retainer wrench | |||
Puller | |||
3 | Remove cap (2). | ||
4 | Remove radial shaft sealing ring (3). | ||
| Install | ||
5 | Install radial shaft sealing ring (3) using drift (9). | Coat sealing lip of radial shaft sealing ring (3) with lubricant. | |
Synthetic grease 50 g | |||
Drift | |||
6 | Install cap (2) with new seal (1). | Screw/nut, housing cover to housing | |
7 | Install power output flange (5). | If exhibiting sluggishness, heat up output flange (5) to approx. 85 °C. | |
8 | Fit pressure disk (6) and tighten screw (7). | Counterhold output flange (5) with retainer wrench (8). | |
Bolt, output flange to output shaft | |||
Retainer wrench | |||
9 | Attach propeller shaft to power take-off. | Propeller shaft to power take-off | |
10 | Check transmission oil level, correct, if necessary. | ||
| Transmission 715.320/350/370/380/500/507/510/513/515/525/540/561 Transmission 715.520 without code G02 (Torque converter clutch (WSK)) Transmission 715.570 except in model 949 | ||
| Transmission 715.520 with code G02 (Torque converter clutch (WSK)) | ||
| Transmission 715.570 in model 949 |
000 589 65 33 00
Puller
717 589 00 31 00
Retainer wrench
387 589 05 15 00
Drift