1 | Dust cap |
2 | Bleed screw |
D26.45-1022-06
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Topical note | Notes on externally invisible brake fluid loss | ||
Topical note | Brake fluid notes | ||
Bleeding | |||
1 | Raise vehicle | ||
2 | Start engine | Run engine for at least 30 s in neutral. | |
3 | Remove cover from brake fluid reservoir | ||
4 | Connect filler/bleeder unit to brake fluid reservoir | ||
| 000 588 01 82 00 Filling unit | ||
Observe manufacturer's operating instructions. | |||
5 | Remove dust cap (1) | ||
6 | Open bleed screw (2) | Collect brake fluid in a suitable container. | |
7 | Switch power take-off on and off five times in succession | Brake fluid must emerge clean and free of bubbles. | |
8 | Tighten bleed screw (2) | Vent screw to power take-off slave cylinder | |
9 | Disconnect filler/bleeder unit from brake fluid reservoir | ||
| 000 588 01 82 00 Filling unit | ||
Use suitable rag to mop up any drops of brake fluid. | |||
10 | Check brake fluid level in brake fluid reservoir, correct, if necessary | ||
11 | Fit cap onto brake fluid reservoir | ||
12 | Conduct engine test run and check power take-off for proper operation and leak tightness | ||
13 | Slide on dust cap (1) | ||
14 | Lower vehicle |
Power take-off |
Number | Designation | Transmission 711.651/660 with code N05 (Power take-off countershaft (2c) without flange) | Transmission 711.680 in model 906, 907 with code N05 (Power take-off countershaft (2c) without flange) | |
BA26.45-N-1012-01A | Vent screw to power take-off slave cylinder | Nm | 16 | 16 |