AR26.45-D-0070B | Remove/install radial shaft seal for output shaft | 23.5.11 |
TRANSMISSION 711.651 in MODEL 906 with ENGINE 646.984 /985 /986 /989
TRANSMISSION 711.660 in MODEL 906 with ENGINE 642.992, 646.985 /986 /989 except CODE (ZG1) Engageable all-wheel drive
TRANSMISSION 711.660 in MODEL 906 with ENGINE 642.992, 646.985 /986 /989 except CODE (ZG2) Permanent all-wheel drive
TRANSMISSION 711.660 in MODEL 906 with ENGINE 642.992, 646.985 /986 /989 except CODE (ZG3) Engageable all-wheel drive with gear reduction
TRANSMISSION 711.660 in MODEL 906 with ENGINE 642.992, 646.985 /986 /989 except CODE (ZG4) Permanent all-wheel drive with gear reduction
D26.45-0065-05
Shown: transmission 711.651
with code N05 power take-off
1 Screw
2 Washer
3 Output flange
4 Radial shaft seal
5 Oil filler plug
Modification notes
23.5.11 | Value modified: Bolt, retaining bracket to frame floor | Model 906 without code ZG1/ZG2/ZG3/ZG4/ZL3 |
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | |
1 | Raise vehicle | ||
2 | Secure vehicle on vehicle lift | ||
3 | Remove retaining bracket from propeller shaft | ||
| |||
4 | Detach propeller shaft from transmission and tie up on substructure | ||
5 | Remove output flange (3) | ||
| |||
| |||
| |||
6 | Remove radial shaft sealing ring (4). | Installation: Coat sealing lip with automatic transmission fluid. | |
| |||
7 | Install in the reverse order | ||
8 | Unscrew oil filler screw (5) and check transmission oil level, correct if necessary | The transmission oil must be at the oil filler hole. | |
| Gear oils (Sheet 235.10) | Sheet 235.10 | |
9 | Screw in oil filler screw (5) | |
Transmission housing
Number | Designation | Trans-mission | Trans-mission | |
BA26.40-N-1002-01A | Oil filler plug | Nm | 50 | 50 |
Gear set, shafts
Number | Designation | Trans-mission | Trans-mission | |||
BA26.50-N-1006-01D | Bolt, output flange to main shaft | Nm | 110 | 110 | ||
Propeller shaft
Number | Designation | Model | ||||
BA41.10-N-1004-01B | Bolt, retaining bracket to frame floor | M121.5 | Nm | 70 | ||
Propeller shaft
Number | Designation | Model | ||||
BA41.10-N-1004-01B | Bolt, retaining bracket to frame floor | M121.5 | Nm | 70 | ||
000 589 65 33 00
Drift
Puller
Pin wrench
901 589 00 07 00
210 589 03 15 00