Remove/install transmission output flange

AR26.40-W-0007B

9.11.09

TRANSMISSION 715.320

W26.40-0055-05

1 Inner radial shaft sealing ring

2 Outer radial shaft sealing ring

3 Output flange

4 Sealing ring

5 Thrust washer

6 Screw

	Remove/install
1	Disconnect propeller shaft from output flange (3)		*BA41.10-N-1003-01F
2	Fit retainer wrench to output flange (3).		*717589003100
3	Unscrew bolt (6), take off thrust washer (5) and sealing ring (4).	Installation: Install new sealing ring (4).
			*BA26.30-N-1004-01C
Danger!	Risk of injury to skin and eyes caused by handling hot or glowing objects.	Wear safety gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
4	Detach output flange (3) from transmission shaft	 Use a suitable puller if necessary. Check contact surface at output flange (3) for wear, install new output flange (3) necessary.
		 Installation: If the output flange (3) cannot be pushed on by hand, then heat the output flange (3) to approx. 80 °C.
5	Remove radial shaft sealing rings (1, 2)		AR26.40-W-3840B
6	Install in the reverse order

 Cover

Number	Designation		Trans-mission 715.320/ 321


BA26.30-N-1004-01C	Stretch bolt, output flange to output shaft	Nm	310

 Propeller shaft

Number	Designation			Model 375.1, 958.0, 970, 972, 974, 975, 976	Model 375.3, 950, 952, 953, 954, 957, 958.2


BA41.10-N-1003-01F	Propeller shaft to transmission output flange	with nut	Nm	105	105
		Thread in flange	Nm	60	-

Retainer wrench

717 589 00 31 00