Test values for cover
Number | Designation | Transmissions 714.100/120/140/143/160/161 | Transmission | |
BE26.30-N-1001-01C | Shims for input shaft bearing cover (preload for input shaft and main shaft) | mm | 0.00...0.15 | 0.00...0.15 |
Housing
Number | Designation | Trans-mission | Trans-mission | ||
BA26.40-N-1005-01H | Bolt, strip clamp to transmission housing | Nm | 10 | 10 | |
Housing
Number | Designation | Trans-mission 714.690/ | Trans-mission 714.691 | ||
BA26.40-N-1005-01H | Bolt, strip clamp to transmission housing | Nm | 10 | 10 | |
001 589 53 21 00
Torque wrench
Dial indicator
Strip clamp
Dial indicator holder
000 589 59 63 00
001 589 75 21 00
343 589 00 40 00
G26.30-3110-01
1 Use strip clamps (1) to preload the bearing outer race (5) while spinning the drive shaft (4) several times.
2 Slacken both screws on the strip clamps (1) again and tighten to specified
torque .
3 Measure distance (A) from the end face of the bearing outer race (5) and the separating surface of the transmission housing to two opposite points and calculate the mean value of these two distances (A).
W26.30-0005-01
4 Insert existing shim (6) into bearing cap (7).
5 Measure distance (B) from the separating surface of the bearing cap (7) and the shim (6) to two opposite points and calculate the mean value of these two distances (B).
6 Determine the difference between the mean value of distance (A) and the mean value of distance (B).
Distance (B) must be equal to or smaller than distance (A) according to the adjustment value specified in the table. If there is a deviation, a suitable shim (6) must be inserted into the bearing cap (7).