1 | Oil lines for oil cooler |
2 | Electrical connector |
3 | Screw |
4 | Bolts |
5 | Rear transmission housing cover |
A | Thread |
G26.30-A001-05
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on self-locking nuts and bolts | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
| Remove | ||
1 | Remove drive flange from transmission. | ||
2 | Unscrew oil lines for oil cooler (1). | ||
3 | Disconnect electrical connection (2). | ||
4 | Remove bolts (3, 4). | ||
5 | Pry off rear transmission housing cover (5); to do so, screw two screws uniformly into threads (A). | Use M14x1.5x50 screws to pry off rear transmission housing cover (5). | |
6 | Remove rear transmission housing cover (5). | ||
7 | Secure oil pump guide pin to prevent it from falling out. | Only if the transmission is removed and turned over for follow-up work. | |
8 | Remove screws from both threads (A). | ||
| Clean | ||
9 | Clean sealing surfaces. | ||
| Install | ||
10 | Remove attached retainer from oil pump guide pin. | Only if the oil pump guide pin was secured against falling out. | |
11 | Apply sealant to the sealing surfaces. | Loctite 5203 sealant | |
12 | Position rear transmission housing cover (5). | ||
13 | Screw in screws (3, 4). | Screw, transmission housing cover to transmission housing | |
14 | Plug in electrical connector (2). | ||
15 | Position oil lines for oil cooler (1) and tighten. | ||
16 | Install output flange on transmission. |