1 | Seal |
2 | Cap |
3 | Shift shaft |
4 | Gate cylinder piston rod |
5 | Gear cylinder piston rod |
6 | Tappet |
7 | Transmission positioner |
G26.21-3134-06
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Shift transmission to neutral position | ||
2 | Release and disconnect electrical connectors of transmission control unit at transmission positioner (7) | ||
3 | Detach compressed air lines from transmission positioner (7) | ||
4 | Pull out transmission positioner (7) up to end stop, pull vertically upward and take off | ||
5 | Remove seal (1) | ||
| Install | ||
6 | Pull gate cylinder piston rod (4) completely and move gear cylinder piston rod (5) to neutral position | ||
7 | Attach transmission positioner (7) with new seal (1) | The plunger (6) must be pushed in up to the end stop. | |
Bolt, transmission positioner to transmission | |||
8 | Attach compressed air lines to transmission positioner (7) | ||
9 | Connect electrical connectors of transmission control unit at transmission positioner (7) | ||
10 | Fill compressed air system using external air source | ||
11 | Connect diagnostic system | Only if the transmission positioner (7) has been replaced. | |
See information provided by vehicle manufacturer or transmission manufacturer. | |||
12 | Perform initial startup of transmission control unit using diagnostic system | Only if the transmission positioner (7) has been replaced. | |
See information provided by vehicle manufacturer or transmission manufacturer. | |||
13 | Detach diagnostic system | Only if the transmission positioner (7) has been replaced. |