S26.19-4517-08
Shown on model 470 with engine 699 and code ZG3 (Engageable all-wheel drive with transmission ratio) |
1 | Electrical connector | 2 | Backup lamp switch |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Lift vehicle with vehicle lift. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
2 | Remove front propeller shaft. |
| |
3 | Remove electrical connector (1) from bracket. | ||
4 | Disconnect electrical connector (1). | ||
5 | Unscrew backup light switch (2). | ||
6 | Remove old screw locking adhesive from thread of backup light switch (2). | If backup light switch (2) is to be reused. | |
Loctite 7063 (400 ml) cleaning spray | |||
7 | Remove old screw locking adhesive from thread of installation opening of backup light switch (2) in transmission. | Loctite 7063 (400 ml) cleaning spray | |
| Install | ||
8 | Apply screw locking adhesive to thread of backup light switch (2). | Thread locking adhesive, Loctite 241 | |
9 | Screw in backup light switch (2). | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
Commercially available devices/tools | |||
Reverse lamp switch at transmission housing | |||
10 | Connect electrical connector (1). | ||
11 | Mount electrical connector (1) onto holder. | ||
12 | Install front propeller shaft. |
| |
13 | Lower vehicle with vehicle lift. |