S26.19-4518-08
Shown on model 470 with engine 699 and code ZG3 (Engageable all-wheel drive with transmission ratio) |
1 | Electrical connector | 2 | Hill Start Assist sensor |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Remove center and rear lower engine compartment lining. | ||
2 | Remove shift cables from transmission. | ||
3 | Remove electrical connector (1) from bracket. | ||
4 | Release electrical connector(1) and disconnect. | ||
5 | Remove Hill Start Assist sensor (2). | ||
6 | Remove old screw locking adhesive from thread of Hill Start Assist sensor (2). | When reusing the Hill Start Assist sensor (2). | |
Loctite 7063 (400 ml) cleaning spray | |||
7 | Remove old screw locking adhesive from thread of installation opening of Hill Start Assist sensor (2) in transmission. | Loctite 7063 (400 ml) cleaning spray | |
| Install | ||
8 | Apply screw locking adhesive to thread of Hill Start Assist sensor (2). | Thread locking adhesive, Loctite 241 | |
9 | Screw in Hill Start Assist sensor (2). | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
Commercially available devices/tools | |||
Hill Start Assist switch at transmission housing | |||
10 | Connect electrical connector (1). | ||
11 | Mount electrical connector (1) onto holder. | ||
12 | Route shift cables and mount onto transmission. | ||
Long-life grease | |||
13 | Install center and rear lower engine compartment lining. |