G26.10-A003-09
1 | Front lifting eyes | 4 | Main shaft | X29 | Transmission electrical connector | ||
2 | Rear lifting eyes | 5 | Bracket | X40 | Retarder electrical connector | ||
3 | Release lever | A16 | Gear control (GS II) control unit |
Topical note | Notes on self-locking nuts and bolts | ||
| Remove/install | ||
1 | Remove engine with transmission. | Select procedure according to design and accessibility. | |
2 | Disconnect transmission electrical connector (X29) from holder (5). | ||
3 | Disconnect transmission oil lines from transmission and seal using suitable stop plugs. | Only for vehicles with transmission oil cooling. | |
4 | Remove transmission oil lines from holders on transmission and engine. | Only for vehicles with transmission oil cooling. | |
5 | Pull tappet out of coupling release lever (3). | Installation: Grease tappet head. | |
Long-life grease | |||
6 | Attach load tilter to transmission. | ||
| 000 588 02 62 00 Load tilter | ||
Hook load tilter into both front lifting eyes (1) and into rear lifting eyes (2) on transmission. | |||
7 | Remove transmission from engine. | Installation: The release lever (3) must engage in the release bearing. | |
Bolt, transmission to engine | |||
8 | Install in the reverse order |