AR26.10-D-0020E | Removing and installing transmission | 20.9.99 |
TRANSMISSION 716.643 in MODEL 901.6, 902.6, 903.6, 904.6
D26.10-1122-09
1 Hydraulic pump connector
2 Central plug connector
3 Bolt
7 Bracket
8 Ground strap
9 Transmission
4 Speedometer sensor
5 O-ring
6 Bolt
| Removing, installing | ||
1 | Remove propeller shaft | 2-piece propeller shaft | |
3-piece propeller shaft | |||
Models 903.6, 904.6 with all-wheel drive, code ZG1/ ZG2/ ZG3 | |||
| Notes on installing propeller shaft | Models 901, 902, 903, 904, 905, 690.6 | |
Installation: Only with all-wheel drive, code ZG1/ ZG2/ ZG3 | |||
Align transfer case relative to transmission | |||
2 | Remove connector cover on right side | ||
3 | Disconnect hydraulic pump connector (1) and central plug connector (2) | Expose cables. | |
4.1 | Remove speedometer sensor (4) | With code J19 | |
Installation: Check O-ring (5) and replace if necessary, and attach lead seal to speedometer sensor. | |||
| |||
5 | Unscrew bolts (6) on underside of transmission | | |
6 | Place hydraulic transmission jack under transmission (9) and raise slightly | Secure transmission with strap. | |
7 | Unscrew starter | Tie back bracket (7) to one side. | |
8 | Unscrew ground strap (8) from transmission | Tie back ground strap to one side. | |
9 | Remove rear engine crossmember | ||
10 | Unscrew remaining bolts (6) | | |
11 | Pull transmission towards the rear and lower | Installation: Ensure that the centering pin is correctly seated. Install starter and allow to mesh in the splines on the flywheel. | |
12 | Install in the reverse order | ||
13 | Initialize gears | With STAR DIAGNOSIS |
Manual transmission complete
Number | Designation | Transmission 716.643 | |
BA26.10-N-1001-01A | Bolt, manual transmission to engine | Nm | 38 |
Sensors/senders