Shown with ENGINE 651 |
1 | Cover |
2 | Socket wrench |
N25.20-2075-11
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Topical note | Brake fluid notes | ||
Bleeding | |||
1 | Clean area surrounding brake fluid reservoir. | Assembly cleaner | |
2 | Mark fill level of brake fluid on brake fluid reservoir. | ||
3 | Unscrew cap from brake fluid reservoir. | ||
4 | Attach filling unit at brake fluid reservoir. | ||
| 000 588 01 82 00 Filling unit | ||
Do not switch on the filling unit yet. Observe manufacturer's operating instructions. | |||
| Remove | ||
5 | Raise vehicle. | ||
6 | Remove cover (1). | ||
7 | Remove cover on central clutch release bearing. | ||
Bleeding | |||
8 | Switch on filling unit. | Set pressure to 2.0 bar. | |
9 | Plug hose of bleed bottle onto vent screw and position socket wrench (2). | Commercially available devices/tools | |
Socket wrench | |||
10 | Open vent screw on central clutch release bearing. | Commercially available devices/tools | |
Socket wrench | |||
11 | Bleed clutch actuation system. | Allow brake fluid to continue pouring out until it is clean and free of bubbles. | |
12 | Close vent screw on central clutch release bearing. | Bleed screw to central clutch release bearing | |
13 | Switch off filling unit. | Pressure must drop for approx. 60 s to ambient pressure (0.0 bar on measuring instrument). | |
14 | Switch on filling unit. | Build up pressure of 2.0 bar for approx. 10 s. | |
15 | Switch off filling unit. | ||
16 | Install cover on central clutch release bearing. | ||
17 | Install cover (1). | ||
18 | Lower vehicle. | ||
19 | Remove filling unit from brake fluid reservoir. | ||
| 000 588 01 82 00 Filling unit | ||
| |||
Observe manufacturer's operating instructions. | |||
20 | Correct fill level of brake fluid in brake fluid reservoir. | Observe the marking on the brake fluid reservoir. | |
21 | Screw cap onto brake fluid reservoir. | ||
| Check | ||
22 | Check clutch operation system for proper operation. | ||
23 | Check clutch operation system for leak tightness. | Visual inspection only. |
140 589 03 09 00
Socket wrench