Remove/install rear engine power take-off.

AR23.20-W-9430B

23.11.10

ENGINES 902.9 in MODEL 375.3, 950.5 /6, 952.5 /6, 953.6, 954.5, 957 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 902.9 in MODEL 375.1, 970, 972, 974, 975, 976 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 904.9, 906.9, 924.9, 926.9 in MODEL 958.0 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 906.9 in MODEL 375.3, 950.5 /6, 952.5 /6, 953.6, 954.5, 957, 958.2 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 906.9 in MODEL 970, 972, 974, 975, 976 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 925.9 in MODEL 970, 972, 974 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 926.9 in MODEL 950.5 /6, 952.5 /6, 953.6, 954.5, 957, 958.2 with CODE (N52) Rear engine power take-off, output torque 600 Nm

W23.20-1000-10

1 Rear engine power take-off

2 Sealing ring

3 Drive flange

 	Remove/install
 Danger!	Risk of injury caused by body parts being pinched or crushed as cab is tilted	Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all the way to end position and secure with safety strut.	AS60.80-Z-0001-01A
1	Tilt cab
	Notes on tilting the cab		AH60.80-N-0003-01A
2	Remove soundproofing on frame at top right and below
3	Disconnect propeller shaft from drive flange (3)	 Only when an auxiliary unit is installed.
			*BA23.20-N-1004-01C
 Danger!	Risk of injury to skin and eyes caused by handling hot or glowing objects.	Wear safety gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
4	Remove rear engine power take-off (1) at timing case	 Slightly heat up the outside of the timing case around the rear engine power take-off (1) using a hot air blower.
		 Installation: Screw in bolts with thread M81.25 as an assembly aid into the timing case. When pressing in the rear engine power take-off (1), observe the hole pattern.
			*BA23.20-N-1002-01C
5	Remove sealing ring (2)
6	Install in the reverse order

 Rear engine power take-off

Number	Designation		Engine 900.9, 902.9, 904.9, 906.9, 924.9, 925.9, 926.9 with code N52


BA23.20-N-1002-01C	Bolt, engine power take-off to timing case	Nm	25
BA23.20-N-1004-01C	Bolt, propeller shaft to drive flange	Nm	25