1 | Screw/bolts |
2 | Left engine mount |
W22.10-1069-06
Shown with code A1A (Air-sprung front axle) |
3 | Right damper (for code A1A (Air-sprung front axle)) |
4 | Screw/bolts |
6 | Right shock absorber mount (for code A1A (Air-sprung front axle)) |
11 | Screw/bolts |
W22.10-1070-06
W22.10-1071-08
Shown without code A1A (Air-sprung front axle) |
5 | Right engine mount | 8 | Right engine support | ||||
7 | Screw/bolts | 11 | Screw/bolts |
W22.10-1072-08
5 | Right engine mount | 9 | Electrical wiring harness | Pfeil A | Guide pins | ||
8 | Right engine support | 10 | Wiring harness mount | Pfeil B | Guide pins |
Danger ! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
| Notes on tilting the cab | ||
| Remove/install | ||
1 | Tilt cab | ||
2 | Disconnect ground line of battery | ||
3 | Remove soundproofing | ||
4 | Hook engine hoist onto the front engine suspension lug | ||
5 | Remove fender liner on the right | ||
6 | Remove screw/bolts (1) from engine mount (2) on the left | Bolt, front engine support to engine mount | |
7 | Remove damper on the right (3) | Only for vehicles with code A1A (Front axle air-sprung). | |
8 | Remove screw/bolts (4) from the engine mount on the right (5) and remove shock absorber mount on the right (6) | Only for vehicles with code A1A (Front axle air-sprung). | |
Shock absorber mount to engine mount | |||
9 | Remove screw/bolts (7) from engine mount (5) on the right | Bolt, front engine support to engine mount | |
10 | Raise engine without tilting until the left engine support (8) is about 1 cm from the right engine mount (5) | | |
Installation: Introduce guide pin (arrow A) onto engine mount on the right (5) and engine mount on the left (2). Place screw/bolts (1, 7) and lower engine. | |||
11 | Support engine from below with a telescopic lifter | ||
12 | Expose electrical wiring harness (9) on right engine mount (5) | ||
13 | Remove wiring harness holder (10) on right engine support (8) | ||
14 | Remove right engine support (8) from crankcase | Bolt, front engine mount to crankcase | |
15 | Remove screw/bolts (11) | Bolt, engine mount to frame | |
16 | Remove right engine mount (5) and right engine support (8) downwards; in doing so push the electrical wiring harness (9) to the side | Installation: Clean mounting surface of right engine mount (5) on the frame. Introduce guide pin (arrows B) on engine mount on the right (5) in the frame. Repair paint points on the screw/bolts (4, 11) and on frame. | |
17 | Install in the reverse order |