Shown on transmission 725.0 without code ZG2 (Permanent all-wheel drive) with removed AdBlue® tank and removed propeller shaft |
1 | Transmission carrier |
2 | AdBlue® line |
3 | Electrical wiring harness |
4 | Bolts |
5 | Screw |
6 | Transmission |
S22.10-A006-76
Shown on transmission 711.6 |
1 | Transmission carrier |
4 | Screw |
7 | Heat shield |
8 | AdBlue® tank |
S22.10-A010-81
Shown on transmission 725.0 with code ZG2 (Permanent all-wheel drive) |
1 | Transmission carrier |
2 | AdBlue® line |
3 | Electrical wiring harness |
5 | Screw |
9 | Nuts |
S22.10-A015-76
| Remove/install | ||
1 | Remove lower engine compartment lining | ||
2 | Remove underfloor paneling at left. | ||
3 | Remove heat shield (7) from AdBlue® container (8). | Engine 654.9 in model 447 | |
4 | Remove AdBlue® line (2) from transmission carrier (1) and place to one side. | ||
5 | Remove electrical wiring harness (3) from the transmission carrier (1) and place to one side. | ||
6 | Support transmission (6) at center. | ||
| 000 588 11 62 00 Major assembly mount | ||
| 000 588 10 62 00 Support plate | ||
7.1 | Remove screws/bolts (4). | Engine 654.9 in model 447 | |
Engine 654.9 in model 447 | |||
7.2 | Remove nuts (9). | Engine 654.9 in model 447 | |
Engine 654.9 in model 447 | |||
8 | Remove screws (5) and remove transmission carrier (1). | Installation: First position screws (5) and then tighten together with the screws (4). | |
Bolt, transmission carrier to longitudinal member | |||
9 | Install in the reverse order. |