Shown on model 247 |
6 | Air intake line |
P20.40-A008-06
P20.40-A007-08
Shown on model 247 |
1 | Electrical connector | 2 | Fan unit |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Warning | Risk of injury due to fan starting unexpectedly | Do not reach into the rotation or hazard area of the fan. Wear closed and close-fitting work clothes. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
| Remove | ||
1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
2 | Remove air intake line (6). | ||
3 | Release electrical connector (1) and disconnect. | ||
4 | Release the air duct segment from the fan unit (2) (arrows B) and push it forward slightly. | ||
5 | Release fan unit (2) from the upper holders (arrows A). | ||
6 | Pull fan unit (2) upwards out of the holders (arrows A, C) until fan unit (2) can be removed from the air duct segment. | ||
7 | Remove fan unit (2) from the air duct segment (arrow). | ||
8 | Remove fan unit (2) from the lower holders (arrows C) and from the engine compartment in an upwards direction. | ||
| Install | ||
9 | Install fan unit (2) in the lower holders (arrows C). | ||
10 | Position fan unit (2) on the air duct segment. | ||
11 | Insert the air duct segment into the guides on fan unit (2). | ||
12 | Pull fan unit (2) out of the lower holders (arrows C) until fan unit (2) can be installed in the upper holders (arrows A). | ||
13 | Install fan unit (2) in the holders (arrows A) until it locks. | ||
14 | Fully install the air duct segment in fan unit (2) until it locks. | ||
15 | Connect and lock electrical connector (1). | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
16 | Perform an engine test run and check fan unit (2) for proper operation. |