D15.40-1122-09
Shown on vehicle up to 31.8.10
1 Poly-V belt
2 Bolts
3 Electrical connector
4 Electrical line
G2/7 Alternator with LIN bus
5 Nut
6 Bolt
7 Bracket
8 Belt pulley
D15.40-1130-11
Vehicle as of 1.9.10
14 Bolts
15 Bracket
Modification notes
| Remove/install | ||
1 | Disconnect battery ground line | ||
2 | Loosen poly-V belt (1) | ||
3 | Remove noise damper | ||
4 | Remove carrier for 2nd refrigerant compressor | For model 906.633/635/653/655 with code (H08) High performance A/C | |
5 | Undo bolts (14) and remove bracket (15) | In vehicles as of 1.9.10 | |
| |||
6 | Remove electrical connector (3) on AC generator with the LIN bus (G2/7) | ||
7 | Detach protective cap, unscrew nut (5) and remove electrical line (4) from alternator with LIN bus (G2/7) | | |
8 | Remove poly-V belt (1) from belt pulley (8) for alternator with LIN bus (G2/7) | ||
9 | Remove bolt (6) | | |
10 | Remove upper bolts (2) and push bracket (7) to the side | | |
11 | Remove lower bolts (2) and remove alternator with LIN bus (G2/7) downwards | | |
| Checking | ||
12 | Check contact surface and freewheel of belt pulley (8) for damage | Freewheel only for vehicles with code (MJ7) ECO Start. For damage to the belt pulley (8): | |
Vehicles with code (MJ7) ECO Start: | |||
Replace belt pulley (8) for alternator with LIN bus (G2/7). | |||
Vehicles with code (MJ7) ECO Start: | |||
Remove alternator with LIN bus (G2/7). | |||
13 | Remove belt pulley (8) for alternator with LIN bus (G2/7). | For replacing alternator with LIN bus (G2/7) for vehicles with code (MJ7) ECO Start. | |
14 | Install in the reverse order | For replacing alternator with LIN bus (G2/7) for vehicles with code (MJ7) ECO Start. |
Turbocharger
Number | Designation | Engine | ||
BA09.40-N-1018-01R | Bolt, bypass tube bracket to alternator bracket | Nm | 9 | |
Alternator