AR15.30-W-7303A | Remove/install series relay | 15.2.12 |
ENGINE 904.9## ## as of 422015 in MODEL 958, 970, 972, 975, 976
mit Starter Teilenummer: A 006 151 22 01
ENGINE 924.9## ## as of 422015 in MODEL 958, 970, 972, 974, 975, 976
mit Starter Teilenummer: A 006 151 22 01
ENGINE 906.9## ## as of 422015 in MODEL 970, 972, 974, 975, 976
mit Starter Teilenummer: A 006 151 22 01
W15.30-1046-11
1 Electrical lines circuit 30 (from starter)
2 Electrical line terminal 30 (from series relay)
3 Electrical line terminal 86 (from series relay)
4 Electrical line terminal 87 (from series relay)
5 Series relay
6 Bolts
7 Assembly pin
M1 Starter
| Remove/install | ||
1 | Switch off ignition | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
2 | Disconnect ground lead from battery | ||
| Notes on battery | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with safety strut. | |
3 | Tilt cab | ||
| Notes on tilting the cab | ||
4 | Disconnect electrical lines of circuit 30 (1) at starter (M1) | | |
5 | Remove electrical line terminal 30 (2), terminal 86 (3) and terminal 87 (4) on series relay (5) | Installation: Tighten nuts with about. 2.5 Nm. | |
6 | Unscrew bolts (6) and remove series relay (5) | Tighten bolts (6) with about 6 Nm. | |
7 | Install in the reverse order | ||
8 | Synchronize tachograph | ||
9 | Reset clock | ||
10 | Code radio |
Starter