AR15.30-W-7100J | Remove/install starter | 15.2.12 |
ENGINES 900.9 in MODELS 375.1, 970, 972, 975, 976
ENGINES 902.9 in MODEL 375.3, 950.5 /6, 952.5 /6, 953.6, 954.5
ENGINES 902.9 in MODEL 957 except CODE (MS8) Natural gas engine
ENGINES 902.9 in MODELS 375.1, 970, 972, 974, 975, 976
ENGINES 924.9 in MODELS 958.0, 970, 972, 974, 975, 976
ENGINES 925.9 in MODELS 970, 972, 974
ENGINES 926.9 in MODEL 950.5 /6, 952.5 /6, 953.6, 954.5, 957, 958.2
ENGINES 926.9 in MODEL 958.0
W15.30-1064-06
1 Electric cable circuit 50
2 Terminal 30 cables
3 Engine wiring harness
M1 Starter
| Remove/install | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all the way to end position and secure with safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
2 | Disconnect ground lead from battery | ||
| Notes on battery | ||
3 | Remove soundproofing on the middle and right below on frame | ||
4 | Remove soundproofing on frame above on the right | ||
5 | Expose engine wiring harness (3) at starter (M1) | ||
6 | Detach electrical line, terminal 50 (1) at starter (M1) | ||
7 | Detach electrical lines, terminal 30 (2) at starter (M1) | | |
8 | Remove starter (M1) | | |
9 | Check starter pinion and starter (M1) for wear | Only when reinstalling the used starter (M1). | |
In case of wear, replace the starter (M1). | |||
10.1 | Inspect ring gear of flywheel for wear | Vehicles with manual transmission | |
If worn: | |||
Replace ring gear on flywheel | |||
10.2 | Check ring gear in ring gear carrier for wear | Vehicles with automatic transmission | |
If worn: | |||
Replace ring gear in ring gear carrier | |||
11 | Install in the reverse order | ||
12 | Synchronize time between tachograph disk and display |
Starter