A15.30-0001-11
2 Nut
3 Electrical wiring
4 Nuts
M1 Starter
| Remove/install | ||
Danger! | Risk of injury to skin and eyes caused by handling hot or glowing objects. | Wear safety gloves, protective clothing and safety glasses, if necessary. | |
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
1 | Disconnect electric cables at battery. | ||
2 | Remove lower engine compartment paneling | ||
3 | Unscrew nuts (4) and remove electrical line (3) from starter (M1) | | |
| |||
4 | Unscrew nuts (2) and remove starter (M1) from timing case | | |
5 | Inspect starter pinion for wear | In case of wear, replace the starter (M1). | |
6 | Inspect ring gear of flywheel for wear | In case of wear, replace flywheel ring gear. | |
7 | Install in the reverse order |
Starter