AR15.30-P-7100I | Remove starter, install | 15.2.12 |
ENGINE 113.960 in MODEL 215.375
ENGINE 112.922 in MODEL 220.063
ENGINE 112.944 in MODEL 220.065 /165
ENGINE 113.941 in MODEL 220.070 /170
ENGINE 113.960 in MODEL 220.075 /175 /875
ENGINE 112.972 in MODEL 220.067 /167
P15.30-2001-06
1 Electric cable circuit 30
2 Electric cable circuit 50
3 Bolts
4 Nuts
M1 Starter
Modification notes
| Remove/Install | ||
Danger! | Risk of death cased by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | |
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
| Notes on self-locking nuts and bolts | ||
1 | Turn key in electronic ignition lock EIS into position "0". | Key cannot be withdrawn. | |
2 | Dismount ground line to the battery | Do not connect quiescent current retention unit. A short circuit could occur, if the electrical line circuit 30 (B+) comes into contact with the ground. | |
Vehicles with Keyless-Go code 889: Switch off engine, remove Keyless-Go cards from the vehicle and store outside of transmitter range | |||
| Note for battery | ||
3 | Detach lower engine compartment paneling | ||
4 | Unscrew bolts (3) | | |
5 | Unscrew nuts (4) and remove electrical lines (1, 2) | | |
| |||
6 | Take starter (M1) down and out | ||
7.1 | Check ring gear on the drive plate for wear and damage | When replacing the starter | |
Rotate engine at the crankshaft in direction of rotation. | |||
8 | Install in the reverse order | ||
9 | Perform function check | ||
10 | Render electrical system operational | See | |
Perform basic programming | |||
11 | Read diagnostic trouble code memory and erase | When the work is complete stored faults must be worked on in the diagnostic trouble code memories and erased. | |
| Connect STAR DIAGNOSIS, interrogate fault memory |
Starter